SK EN 60309-2:2013

Spinat, prizat, prizat me fisha dhe qiftezuesit per qellime industriale -Pjesa 2 : Kerkesa per ndershkembyeshmerine dimensionale per aksesoret me spine (kunj) dhe me tub kontakti

Plugs, socket-outlets and couplers for industrial purposes - Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories of harmonized configurations

Asnjë informacion i shtuar.

This standard applies to plugs and socket-outlets, cable couplers and appliance couplers with a rated operating voltage not exceeding 690 V, 500 Hz and a rated current not exceeding 125 A, primarily intended for industrial use, either indoors or outdoors. All references for accessories with a rated current of more than 125 A in Part 1 are not applicable for this Part 2. This standard applies to plugs and socket-outlets, cable couplers and appliance couplers with pins and contact tubes of standardized configurations. This standard applies to plugs and socket-outlets, cable couplers and appliance couplers, hereinafter referred to as accessories, for use when the ambient temperature does not normally exceed 40 C. The use of these accessories on building sites and for agricultural, commercial and domestic applications is not precluded. Socket-outlets or appliance inlets incorporated in or fixed to electrical equipment are within the scope of this standard. This standard also applies to accessories intended to be used in extra-low voltage installations. This standard does not apply to accessories primarily intended for domestic and similar general purposes. In locations where special conditions prevail, for example on board ship or where explosions are liable to occur, additional requirements may be necessary.

SK EN 60309-2:2018 replaces SK EN 60309-2:2013 - 2016-07-22

Ky standard shfuqizohet nga edicioni i ri!